Vanox LYRA VZB28BN Operation Instructions Manual - Section 8:
Section 8:
Operation:
Lighting Instructions
SIT Millivolt Valve:
FOR YOUR SAFETY -R EAD BEFORE LIGHTING:
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. This appliance has a pilot which must be lit by
hand. When lighting the pilot, follow these
instructions exactly .
If you cannot reach your gas supplier, call the
Fire Department.
C. Use only your hand to push in or turn the ga s
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next
to the floor
because some gas is heavier than air and will
settle on the floor.
control knob. Never use tools. If the knob will not
push i n or tur n by hand, don't t ry to repair it, call
a qualified servi ce technician. Force or attempt to
repair may result in a fire or explosion.
What To Do If You Smell Gas:
D. Do not use this appliance if any part has bee
n
Do not try to light any appliance
.
Do not touch any electrical switch; do not us e
under water. Immed iately call a qualified service
technician to inspect the appliance and to replace
any part of the control system, and any gas
control which has been under wat
er.
any phone in your building .
Immediately call your gas supplier from a
neighbour's phone. Follow t he g as s upplier's
instructions.
LIGHTING INSTRUCTIONS:
1. STOP! Read the sa fety information above on this 5. Locate pilot burner
(See illustration at right.)
and
follow steps below .
label.
2. Locate the gas control behi
nd t he lower trim, o r6
. Turn knob on gas control counterclockwise to
"PILOT."
on the rear left side (on Cast stoves) .
3. Push in gas control knob and turn clockwis
e
7. Push in gas control knob completely and hold.
C'
1
4
to "OFF."
Light with P iezo I gniter b utton. C ontinue to h old the
control knob in for about (1) minute after the
4. Wait five (5) minutes to clear out any gas. Smell fo
r
gas, including near the floor. If you then smell gas,
STOP! Follow "B" in the safet y
information above on thi s
label. If you don't smell gas ,
go to the next step.
.1
pilot is lit. Release the knob
and it will pop back up. Pilot
shoul d remain lit. If it goes
out repeat steps 3 through 8 .
0
1I
Typical pilot show
", see
i "structio"ma "ual for pilot
specific to
your model
.
If knob does not pop up
when rel eased. Stop an d
NOTE: Knob cannot be turned from
"PILOT" to "OFF" unless kno
b
Gas Control Knob
immediately call your
is pushed in slightl
y. Do not force.
(Shown in "Pilot" postion.)
service technic ian or gas
.
SIT 820
HI/LO VALVE.
supplier.
If the pilot will not stay lit after several tries,
turn t he g as c ontrol k nob to " OFF" a nd call
your service technician or gas supplier.
8. Push in gas control knob and turn
counterclockwise
to "ON."
L
Gas Control Knob
(Shown in "Pilot" postion.)
9. Turn on remote switch to ignite fire.
HONEYWELL
VALVE.
SIT 820 ON
/OFF V
ALVE.
TO TURN OFF GAS TO APPLIANCE:
2/3
0N2P009611B/L
-
1. Turn off remote switch.
3. Push in gas control knob slightly and turn
clockwise to "Off". Do not force.
2. Locate the gas control behind the lower trim, or on the
rear left side of the unit.
Part. No.
VZB28BN-Man-101817-A
VZB28BN Gas Fireplace
VANOX Fireplace Inc.
Page 19