Vanox LYRA VZB28BN Operation Instructions Manual - Section 9:
Installation and Servicing:
The VZB28BN and VRI28BN gas fireplace is factory
equipped with a 120VAC, 60Hz. circulating blower.
The circulating fan has been designed to increase the ef-
ficiency of convection heat by providing a very quiet air
flow over the combustion chamber of the fireplace and
discharging heated air into your living space.
The fan can be controlled by turning the black knob (lo-
cated below the control compartment) clockwise to slow
the fan down, and counterclockwise to speed the fan up.
The blower is automaticaly controlled by a thermally
activated switch positioned which is behind behind the
burner and below the burner tray. It will be activated when
the Fireplace has heated up, (automatically 15-20 minutes),
and will prevent the fan from operating when the fireplace
is cold.
NOTE: ALL electric work on this fireplace must conform
with local building codes, and CSA 2.22 electrical code
requirements.
DO NOT USE the fireplace without the fan!
FOR INSTALLATIONS WITH 4” DIAMETER VENTING THE
SPEED OF THE FAN SHOULD BE SET MIDWAY!
Section 9:
Mandatory fan kit
WARNING
Electrical grounding instructions. This appliance is
equipped with a three-pronged (grounding) plug for
your protection against shock hazzard and should be
plugged directly into a properly grounded three-e-
pronged receptacle. Do not cut or remove the ground-
ing prong from the plug.
AVERTISSEMENT
Électriques instructions de mise à la terre. Cet
appareil est équipé d'un à trois broches (mise à la
terre) prise pour votre protection contre les chocs
hazzard et doit être branchée directement dans une
prise à trois broches. Ne pas couper ou enlever la
broche de terre de la fiche.
Fan Installation:
The steps to install the fan.
1). Cut 10” (ten inches) off the rear 1/2” ledge as per the
sketch below in order to improve the fan flow.
2). Place the Place the fan mounting support under the
1/2” ledge and secure with four (4) screws on the legs of
the Montigo 28 Series fireplace.
Ensure to support properly, and fasten securely in order to
avoid the fan from making noise when running.
3). Connect the male motor connector to the fan wiring
harness. Figure 34.
4). The fan switch is factory installed under the burner tray,
on the left hand side.
5). After connecting the wiring harness bundle wires to-
gether to keep them away from the fsn blades and bottom
pan.
IMPORTANT
DISCONNECT POWER SUPPLY BEFORE
SERVICING
0
0.4
0
5.2
0
5.2
0
0.1
0
5.2
Cut 10" on the Edge
for Fan
Cut 2.5"
Cut 4"
Part. No.
VZB28BN-Man-101817-A
VZB28BN Gas Fireplace
VANOX Fireplace Inc.
Page 23