VAPamore MR-500 Vento Instruction Book And Users Manual - page 8
USING YOUR MR-500 VENTO
Fig. 12
GO TO VAPAMORE.COM TO SEE THE MR-500 VENTO INSTRUCTIONAL VIDEO
contact Vapamore service at 480-951-8900. Fig. 12
ELECTRIC FLOOR HEAD
Fig. 13
Fig. 14
Fig. 15
Fig. 16
upright/stored and operating. When in the upright/stored
position the handle is locked into place. To lower the
handle to the operating position, push the handle release
pedal. Fig. 13
depending on the surface being cleaned. If cleaning rugs
or carpet turn on the rotating brush. If cleaning hard
vacuum on. Fig. 15
Always check to make sure the rotating brush is clear and
free of any pet hair or debris. Remove and clean any built
up debris from the rotating brush. Also make sure the
Note: The rotating brush uses a special designed drive
belt. In the case that the drive belt should break due to
over stress or a brush jam, contact Vapamore for service at
480-951-8900 or visit vapamore.com to order a
replacement drive belt.
Handle
release
petal
Reset button
RESET
RESET
HEIGHT
Carpet
height
adjuster
Carpet height indicator
petal
Keep intake
and brush
clear of
debris
The carpet height adjuster has a range of 1-6 and is
adjusted in according to the surface being cleaned.
Always adjust going up (1 up to 6) until you reach the
desired setting. When adjusting down (6 down to 1)
the adjuster is designed to skip numbers to return to
1 faster. Adjust by depressing the foot pedal located