Varytec LED Accu Penta User Manual - page 17
17 / 24
defined)
Press the button and “+” “‐“, could adjust Amber
intensity(1‐6 color effect could mixing, user
defined)
Press the button and “+” “‐“, could adjust white
intensity(1‐6 color effect could mixing, user
defined)
Press the button and “+” “‐“, could adjust UV
intensity(1‐6 color effect could mixing, user
defined)
Press the button, full bright mode
Press the button, Red + Blue
Press the button, Green + Blue
Press the button to “IR MODE”
Press the button to UV
Press the button for store
6.2. Master/Slave
Master setting:
The master should be one of following modes: built-in modes, color jumping Mode,
fade mode, white strobe mode and auto dimming mode. It sends out synchronizing signal. To avoid
the master signal and DMX512 signal from interfering with each other, we should cut off the DMX512
signal. When the signal cables are longer than 60 meters, a DMX signal amplifier is necessary.
Slave setting:
It must be in DMX mode, address code is 001 and CHnd is 15Ch to assure receiving
the master’s signals correctly. Only one light can be set as a Master and others are slaves.