Vaterra GLAMIS UNO Owner's Manual - page 13
EN
PROGRAMMABLE VALUE
DEFAULT SETTINGS
PROGRAMMABLE ITEMS 1
2
3
4
5
6
7
8
1 Running Mode
Forward
Only with
Brake
Forward/
Reverse
with Brake
2 Drag Brake Force
0%
5%
10%
15%
20%
25%
30%
40%
3 Low Voltage Cutoff
Threshold
non-
protection
2.6V/Cell
2.8V/Cell 3.0V/Cell 3.2V/Cell 3.4V/Cell
4 Start Mode (Punch)
Level 1
Level 2
Level 3
Level 4
5 Max Brake Force
25%
50%
75%
100%
DESCRIPTIONS
1 RUNNING MODE
»
Forward Only with Brake
Intended for competition use, this
mode allows only forward and brake
controls.
»
Forward/Reverse with Brake
This mode is the basic all-around
mode, allowing forward, reverse and
brake controls. To engage reverse
while moving forward, apply the brake
until the vehicle has come to stop.
Release the brake, then apply the
brake again. While braking or in
reverse, engaging the throttle will
result in the vehicle immediately
accelerating forward.
2 DRAG BRAKE FORCE
Adjusts the amount of brake auto-
matically applied when the throttle is
returned to neutral. This simulates the
engine braking effect of a full-scale
vehicle, allowing improved turn-in and
your vehicle’s general response to
controls.
3 LOW VOLTAGE CUTOFF
THRESHOLD
This function helps to prevent battery
over-discharge. The ESC continuously
monitors the battery’s voltage. If the
voltage falls below the voltage threshold
for 2 seconds, the output power shuts off
and the red LED flashes twice repeatedly.
The cutoff threshold calculation is based
on individual Li-Po cell voltage. For Ni-MH
batteries, if the voltage battery pack is
higher than 9.0V, it will be treated as a
3-cell Li-Po battery pack; if it is lower
than 9.0V, it will be treated as a 2-cell
Li-Po battery pack. Example: for a 8.0V
Ni-MH battery pack used with a 2.6V/
cell threshold, it will be treated as a 2-cell
Li-Po battery pack and the low-voltage
cutoff threshold will be 5.2V (2.6x2=5.2).
Using the optional Digital Program Box
(DYN3748), you can adjust the custom
values for the cutoff threshold. Unlike the
preset values, custom cutoff values are
for the total battery voltage, not
individual cell voltage.
4 START MODE (PUNCH)
Sets the initial throttle punch when the
car accelerates. Level 1 gives a very soft
initial acceleration and level 4 gives a
stronger initial acceleration.
5 MAX BRAKE FORCE
Adjusts the maximum braking force. A
higher value provides stronger braking,
but can also cause the wheels to lock,
resulting in loss of control of the car.
DYNAMITE 70A WATERPROOF SENSORLESS BRUSHLESS ESC
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /