Vaterra TWIN HAMMERS KIT Owner's Manual - page 9
EN
the VehiCle battery
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
Caution: NEVER remove
the transmitter batteries while the
vehicle is powered ON, as loss of
control, property damage or
injury may result.
1 Ensure the ESC is powered OFF.
2 Loosen the hook and loop straps.
3 Install a fully charged battery.
4 Tighten the hook and loop straps.
5 Power ON the transmitter,
then the vehicle.
the transmitter
/ / / / / / / / / / / / / / /
/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
inStallinG the tranSMitter BatterieS
1 Push in the battery cover a small
amount to release the retaining tab,
then remove the cover.
2 Install 4 AA batteries, taking care
to align the battery polarity to the
diagram in the transmitter’s
battery case.
3 Carefully reinstall the battery cover
by aligning the tabs with the slots
on the transmitter.
Caution: If using rechargeable
batteries, charge only rechargeable
batteries. Charging non-rechargeable
batteries may cause the batteries to
burst, resulting in injury to persons
and/or damage to property.
inStallinG the Vehicle Battery