User guide carpet washer get cleaning... What’s your vax’s model number? What’s your serial number? (located on the base of the machine) note these down in case you need them in future. Please keep instructions for further use. Vax careline: au: 1300 361 505 nz: 0800 800 900 www.Vax.Com.Au 88000 w w...
Vax service line au: 1300 361 505 / nz: 0800 800 900 machine overview 1 handle 2 clean solution reservoir 3 clean solution reservoir latch 4 dirty water tank latch 5 dirty water tank handle 6 rotating brush bar 7 dirty water tank 8 dirty water tank lid 9 vacuum on/off switch 10 brush bar on/off swit...
Www.Vax.Com.Au 2 general safety information for house hold use only. When using the carpet washer, basic safety precautions should always be observed, including the following: 1. Do not leave the carpet washer unattended when plugged in. Unplug it from socket when not in use. 2. To prevent electric ...
Vax service line au: 1300 361 505 / nz: 0800 800 900 3 operation assembling your carpet washer align tabs on tool caddy with slots on midsection and snap into place. Stand the base in the upright position. Assemble the mid section onto the base, taking care not to trap internal mains wire. (phillips...
Www.Vax.Com.Au 4 operation tool caddy use wrap the cord around the upper and lower cord clips. Run the hose to the upper caddy and press into hose clip #1. (see image above for hose clip position.) detach the upholstery hose adapter from the end of the hose and slide it onto the adapter post. Slide ...
Vax service line au: 1300 361 505 / nz: 0800 800 900 5 operation how to operate your cleaner important: turn off when emptying and filling the reservoir. Grasp the solution reservoir under the handle and press the release lever upward. Fill the measuring cap 3 times with vax aaa carpet cleaning solu...
Www.Vax.Com.Au 6 operation how to operate your cleaner continued... Plug the cord into a mains electricity socket. Turn the power and brush bar switches on. The switches are located on the front of the cleaner, above the solution reservoir. The power switch controls the vacuum motor and pump. The br...
Vax service line au: 1300 361 505 / nz: 0800 800 900 7 operation upholstery cleaning note: do not over saturate the upholstery. Important: for best cleaning results use steady, moderate, backward and forward motion. Make sure upholstery is dry before use. Note: if the hose attachment door is not rep...
Www.Vax.Com.Au 8 operation using the hose attachment carry handle storing tools turn power switch on and brush bar switch off. While depressing the solution spray trigger, pull attachment in backward motion. Release trigger and push attachment forward over the same path to remove dirty water and sol...
Vax service line au: 1300 361 505 / nz: 0800 800 900 9 emptying the dirty water tank important: the float in your rapide is the blue piece in the dirty water tank lid. It will shut off the suction when the dirty water tank is full. However, the float may rise prematurely cutting off the suction befo...
Www.Vax.Com.Au 10 maintenance (keep your vax as good as new) cleaning the dirty water tank rinse the dirty water tank and filter thoroughly with warm water. You should allow them to dry fully before replacing them on your cleaner to prevent mildew. Do not use any chemicals in the cleaning process. R...
Vax service line au: 1300 361 505 / nz: 0800 800 900 11 maintenance (keep your vax as good as new) belt or brush removal and replacement (phillips screwdriver required) the plug must be removed from socket outlet before cleaning or maintaining the appliance. Switch off the mains power and unplug car...
Www.Vax.Com.Au 12 maintenance (keep your vax as good as new) belt or brush removal and replacement continued... (phillips screwdriver required) when replacing the belt, first slide it onto the motor shaft. Then slip the brush roll through the belt. Place the belt in the area of the brush without bri...
Vax service line au: 1300 361 505 / nz: 0800 800 900 13 faq’s problem cause solution cleaner won’t run power cord not firmly pushed into a mains socket. Plug cord in firmly. Blown house fuse or tripped circuit breaker. Check fuse/breaker. Replace fuse or reset breaker. Vacuum won’t pick up/loss of s...
Www.Vax.Com.Au 14 other information vax service & help vax careline: australia 1300 361 505 new zealand 0800 800 900 monday–friday 8.30am to 5.00pm if you have queries or concerns about using your vax, call the vax careline. Calls are charged at the standard local rate. Please make a note of the ser...
Distributed by techtronic industries pty. Ltd. Level 1, 660 doncaster road, doncaster, australia 3108. Www.Vax.Com.Au service line: au: 1300 361 505 / nz: 0800 800 900
