Vax 88000 User manual - page 11
www.vax.com.au
10
Maintenance
(Keep your Vax as good as new)
Cleaning the dirty water tank
Rinse the dirty water tank and filter thoroughly with warm water.
You should allow them to dry fully before replacing them on your
cleaner to prevent mildew.
Do not use any chemicals in the cleaning process.
Replacing the dirt water tank
Lift the front of the
carpet cleaner base off
the carpet with one
hand.
While making sure the
dirty water tank is
resting on the base,
place the rear of the
tank into the base of
the cleaner, pushdown
on the handle until it
latches.
Grasp the handle and hook the front of the dirty
water cleaner into the base, making sure that the
front of the dirty water tank is resting on the
base.
The dirty water tank has three tabs on the
underside which MUST latch on to the underside
of the base of the cleaner. The base must be
lifted so that the nozzle is flush with the base of
the cleaner.
Failure to install the dirty water tank correctly will
result in poor dirty water pick up.