Vax Navigator RBNAV1B1 User Manual - 5 Use
15
5 Use
5
Use
5.1 How to vacuum
1. Turn on the cleaning robot. To do this, ei-
ther press the robot's "On/Off" key (
)
for more than 1 second or press the "
"
key on the remote control.
- A short beep occurs.
- Both LEDs are lit.
2. Press the robot's "On/Off" key (
) or the
"
" key on the remote control shortly to
start the robot.
- A tune is played.
- The red LED turns off. The blue LED is
still lit.
- Your robot starts in power mode;
- if you want to adapt the cleaning rate,
see ZChapter 5.2, "Switching between
power or silent mode".
- Based on certain conditions such as the
underlying surface, room geometry, ob-
stacles and so on your robot will switch
modes (Fig. 15/1 to 4) to achieve opti-
mum efficiency.
WARNING:
Danger of injury! You can let your robot run
unsupervised, however always be careful
not to step on it, this could cause you to fall.
Go
A
14
1
2
3
4
15
CAUTION:
Although your robot recognises drop-offs,
we strongly advise against using it on furni-
ture. It is not suitable for this type of use.
NOTE:
Alternatively, you can activate the mode
you prefer via remote control. Just press
one of the following keys: "
", "
",
"
".
Note that best cleaning results are
achieved, if your robot combines all 4
modes automatically.
Go
16
5 Use
Alternatively, you can choose the "auto"
mode with the "
" key of the remote
control.
- Your robot will then effect 2 complete
cleaning cycles (including one charging
cycle).
Alternatively, you can guide the robot di-
rectly via the direction keys "
", "
",
"
", "
" of the remote control.
- Your robot will then move into the cho-
sen direction.
- Your robot can only effect one direction
at once.
Go
A
16
Go
A
24
HOUR
17
NOTE:
When the capacity of the battery pack
diminishes, your robot searches for the sig-
nal of the docking station, docks on and
charges for approx. 4 to 5 hours. Then the
LEDs turn off and the robot can be used.
If it - for any reason - does not succeed in
docking onto the docking station, you have
to lift it manually onto the docking station,
see ZChapter 3.4, "Charging the battery
pack for the first time"
NOTE:
Cliff sensors detect stairs and other cliffs to
avoid falling. A height difference of 7 cm or
more would be judged as a cliff. When a cliff
is detected, your robot will move backwards
to avoid falling. Your robot will stop immedi-
ately if all 3 cliff sensors detect a cliff simul-
taneously.
A
RBNAV1B1_Navigator_Robot_UG_Amd_190216.indd 17
19/02/2016 10:43