Vax Navigator RBNAV1B1 User Manual - 5 Use
17
5 Use
5.2 Switching between power or silent mode
After starting, the robot cleans in power mode.
1. Press the "
" key on the remote control
once to enable silent mode if necessary.
2. Press the button again to switch back to
power mode.
5.3 Erecting a light fence
Proceed as follows to erect a light fence:
1. Set the light fence tower in a place that
your robot will not pass (Fig. 19).
2. Switch the light fence tower's power
switch to "On".
- The tower's LED is lit and then blinks.
- An invisible light fence is built up.
3. Now power on the robot. It will not pass
the fence.
5.4 Erecting a smart fence
1. Erect a light fence as described in
Z
Chapter 5.3, "Erecting a light fence".
2. Press the "
" key on the remote control
to activate smart fence.
- A short beep occurs.
- An invisible smart fence is built up.
3. Now power on the robot. Your robot will
completely clean the room it is in. Then it
will pass the light fence to clean the adja-
cent room.
24
HOUR
18
NOTE:
Once you have chosen the power mode,
the suction rate and working speed are
higher than in silent mode and therefore
your robot consumes more electricity.
19
24
HOUR
20
NOTE:
To deactivate the smart fence function,
press the "
" key again. You will hear
two short beeps.
18
5 Use
5.5 Scheduling a cleaning cycle
There are 2 ways to schedule cleaning:
Cleaning right now and same time each
day:
1. Press the "
" key on the remote con-
trol.
- Your robot will start cleaning right away.
- Your robot will start cleaning at the
same time each day.
Cleaning in 1, 2, 4 or 8 hours
If you press the "
" key once:
- You will hear one beep sound.
- Then the appliance will start cleaning af-
ter 1 hour.
If you press the "
" key twice:
- You will hear two beep sounds.
- The appliance will start cleaning after 2
hours.
If you press the "
" key three times:
- You will hear four beep sounds.
- The appliance will start cleaning after 4
hours.
If you press the "
" key four times:
- You will hear eight beep sounds.
- The appliance will start cleaning after 8
hours.
Go
A
24
HOUR
21
NOTE:
To deactivate this timer, press the "
"
key again.
NOTE:
To deactivate this timer, press the "
"
key for 2 to 3 seconds.
24
HOUR
24
HOUR
RBNAV1B1_Navigator_Robot_UG_Amd_190216.indd 18
19/02/2016 10:43