Vax UCNBAWC1 Let's get started - Taking Care of Your Machine
Taking care of your machine
Press the dirt container
release button, pull to remove.
Emptying the dirt container
Cleaning the carbon pre-motor filter
Hold the dirt container
over a bin.
Press the dirt release clip,
allowing dirt/debris to fall out.
Turn the dirt container lid anti-
clockwise and lift to remove.
Turn the carbon pre-motor filter
anti-clockwise, pull to remove.
Tap the carbon pre-motor filter over
a bin to remove any dirt/debris.
Line up the carbon pre-motor filter
tabs in the dirt container lid and turn
clockwise until it clicks into place.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the machine should overheat,
the thermostat will automatically turn the machine off. Switch off and unplug the vacuum cleaner. Check the
machine for blockages and clean the filters.
Filters require cleaning at least every 3 months (depending on the level of use).
Don’t use your vacuum cleaner without all the filters in place.
TIP
Don’t over fill the dirt container
to avoid blocking the air flow
through the vacuum cleaner.
Replace filters at least
every 6-9 months.
IMPORTANT: Do not wash, scrub or brush the carbon pre-motor filter as this will damage it.
!
40˚C
MAX
24hr