VCON HD100 Getting Started Manual - page 10
10
VCON HD100 Getting Started Guide
Setting Up the HD100 Network Configuration
6. Restart the HD100. Startup information prints inside the HyperTerminal.
7. Press any key to stop the running of the HD100.
8. After the prompt, “[VxWorks Boot]
:
”, type C and press
9. A series of HD100 parameters will appear with their current values. To
change a parameter, type the change in the line after the current value and
then press
changing anything.
Set the parameters as follows:
After passing the “other” entry, the HD100 will reprogram the Flash
memory with this new set of parameters. This process may take up to 2
minutes. The HD100 is ready when the following prompt appears in the
HyperTerminal window:
[VxWorks Boot]
boot device : cf=0,00
processor number : 0
host name : vxhost
file name : cf0:ver\bin\vxworks
inet on ethernet (e) :
inet on backplane (b):
host inet (h) : .
gateway inet (g) : ADDRESS> user (u) : tetra_vc ftp password (pw) (blank = use rsh): tetra_vc flags (f) : 0x0 target name (tn) : tetra_vc startup script (s) : other (o) : rtl CAUTION DO NOT turn off the HD100’s power during the Flash reprogramming! Turning off the power at this stage will prevent the HD100 from initializing, therefore requiring service.