VCON HD100 Getting Started Manual - 2.2
VCON HD100 Getting Started Guide
9
Setting Up the HD100 Network Configuration
5. To set various settings according to your specifications, press the arrow
buttons to navigate to each item, and press
Enter the appropriate changes and press
The HD100 now restarts.
6. After the HD100 has completed starting, press the Pause button to
open the Status dialog. Verify that your settings are correct.
7. To exit the Status dialog, press the
2.2
Setup from the HD100 Debug Terminal
To configure the HD100 through the debug terminal, you may gain access over a
RS-232 connection.
Use COM1 to configure basic LAN parameters and to get debugging information.
➤
To connect the RS-232 serial cable
1. Connect one end of the RS-232 serial cable (DB9-to-DB9) to the serial
port of your computer.
2. Connect the other end to the RS-232 serial port (Port 1) on the rear panel
of the HD100 Integrator.
➤
To start a communications session
1. Set up a HyperTerminal session. In the Windows desktop, run
Start>Programs>Accessories>Communications>HyperTerminal.
2. In the Connection Description dialog box, enter a Name. Select an icon.
Click OK.
3. In the Connect To dialog box, select port COM1 from the Connect Using
list. Click OK.
4. In the COM Properties dialog box, enter the following Port Settings:
5. Click OK.
Bits per second
9600
Data Bits
8
Parity
None
Stop Bit
1
Flow Control
None