VDO Cyclecomputing x3dw Instruction Manual - 3.2 Timer-Functions
X3DW
VDO CYCLECOMPUTING
36
F
I
D
GB
3.2 Timer-Functions
The X3DW has 7 different selectable timers.
Only the timer selected is shown on the display.
STOPWATCH
You can use the stopwatch to measure as ma-
ny times as you want. Maximum value: 23:59:59
HH:MM:SS. If the maximum value is exceeded,
the counter starts again at zero.
Start with
M
. Stop with
M
.
Reset with
C
for 3 seconds.
TIMER1, TIMER2, TIMER1+2
A time can be entered for TIMER1 and TIMER2.
The timer counts up to the set time, jumps back to
zero and counts again up to the set time.
At the end of TIMER1, 1 beep is heard, at the end of
TIMER2, 2 beeps are heard. TIMER1+2 combines the
two timers, e.g. for interval training.
The number of repeats for TIMER1+2 can be entered
beforehand.Maximum value 23:59:59 HH:MM:SS,
99 repetitions. Start with
M
. Stop with
M
.
Reset with
C
for 3 seconds.
COUNTDOWN
On the countdown timer, a time can be set.
The timer counts down backwards from this time
to zero. At the end of the countdown a beep is
heard. Start with
M
. Stop with
M
.
Reset with
C
for 3 seconds.
TIME TRIAL
On the TIME TRIAL timer, a distance can be set
(time trial distance). Whilst cycling, the expected
ride time, based on the average speed and the
distance still to be cycled, is constantly shown
alternately on the display.
Start with
M
. Stop with
M
.
Reset with
C
for 3 seconds.
LAP TIMER
The lap timer can store 30 laps.
For every lap, the following is saved:
B
Time
B
Distance
B
Average speed
The next lap can be started either manually or
automatically. For the automatic start, a distance
is preset. Once this distance has been cycled, the
next lap is started automatically.
Start the 1
st
lap with
M
. Start all other laps with
C
.
Stop with
M
. Reset with
C
for 3 seconds. The lap
counter is set to 1. The stored lap data can be
recalled under:
NAVIGATOR/SELECT
SELECT shows that there is a submenu for the main
NAVIGATOR menu. You open the submenu with
M
.
B
Set
You can set a starting value here and decide whether
the counter counts forwards or backwards from
this starting value. Further details in Chapter 5.7.
B
Reset
In the reset submenu you set the NAVIGATOR
back to zero. You leave the submenu by pressing
C
again.