• 6 models: - sap appendix q eligible 3 speed continuous running - timer - humidity control - selv - low voltage • for all domestic wet rooms • for walls, ceilings or windows ipx4 ipx7 쓑 elegance low carbon fan with ec motor installation and operating instructions.
"elegance” - high performance, low carbon fans installation and operating instructions this leaflet must be available to the user the product you have purchased is an extractor fan for exhausting directly outside or through medium lengths of ducting and is suitable for wall, ceiling or window (with ...
Warning: damage could be caused to the product if the installation instructions are not followed • the product should not be used in an ambient temperature higher than 40°c (104°f). • the product should not be exposed to atmos- pheric agents (rain, sun, snow, etc.). • the product or its parts should...
Adjustable over-run timer (adjustable from 0 to 30 minutes) has completed its cycle. The boost speed can also be activated by as described for model el1003dt el1003hdtlv - selv, 12v version of el1003hdt 4 installation 1 2 3 4 5.
5 6 7 9 8 10
5 6 11 installation 1. Check there is nothing missing in box 2. Remove front cover 3. Drill hole in wall - allow extra width if using ducting - it is the installer's responsibility to use the appropriate core cutter to obtain the correct hole diameter. 4. Use fan assembly as template to mark drill h...
Els - 3 speed with cord 7 wiring diagrams jumper switch these fans are designed to run continuously at one of 2 lower speeds fixed at installation using the jumper switch. El1003, el1003dt and el1003hdt: minimum speed 1 - jumper 2 in minimum speed 2 - jumper 2 out to activate delay-on timer in el100...
Trimmer adjustment to adjust the humidistat and timer trimmers, remove the front cover of the fan (fig 2) to access the trimmers. The humidistat (hy) can be adjusted between 40% and 90% relative humidity. Turn clockwise to decrease sensitivity and set at a higher level of relative humidity. The time...
