Vectaire ELEGANCE EL1003DT Installation And Operating Instructions Manual - page 7
ELs - 3 Speed with Cord
7
WIRING DIAGRAMS
JUMPER SWITCH
These fans are designed to run continuously at one of 2 lower speeds
fixed at installation using the jumper switch.
EL1003, EL1003DT and EL1003HDT:
Minimum Speed 1 - Jumper 2 in
Minimum Speed 2 - Jumper 2 out
To activate delay-on timer in EL1003DT and EL1003HDT, remove
Jumper 3
(N.B Jumpers 1 and 3 will be pre-set at the factory, depending on the
fan model you have)
The user can boost the fan speed to its maximum performance by using
cord or remote switch .
N.B When installing fans via a remote switch, pullcord switch must be
left in "off" position and the cord removed.
ELs - 3 Speed via remote switch
SELV with Pull Cord Switch
EL1003LV - 3 Speed with Cord
EL1003DTLV - 3 Speed with Timer and Cord
EL1003HDTLV - 3 Speed with Humidistat, Timer
and Cord
SELV with External Switch
EL1003LV - 3 Speed
EL1003DTLV - 3 Speed with Timer
EL1003HDTLV - 3 Speed with Humidistat and
Timer