Vector 0 Owner's Manual & Warranty Information

Manual is about: 3,000,000 POWER SERIES SPOTLIGHT RECHARGEABLE WITH BUILT-IN AREA LIGHT

Summary of 0

  • Page 1

    Vec120s owner’s manual & warranty information 3,000,000 candle power s p o t l i g h t c o r d e d • c o r d l e s s • r e c h a r g e a b l e c o r d e d • c o r d l e s s • r e c h a r g e a b l e this manual contains important information regarding the operation and warranty of this product. Plea...

  • Page 2: Warnings:

    Important safety instructions warnings: contains non-spillable sealed lead acid batteries. They must be recy- cled or disposed of properly. Do not dispose of batteries in fire, as this may result in an explosion. Do not open battery or short circuit, as this may cause the battery to leak or get hot ...

  • Page 3

    Two year limited warranty registration form this limited warranty program is the only one that applies to this product, and it sets forth all the responsi- bilities of vector manufacturing, ltd., regarding this product. There is no other warranty, other than those described herein. This vector manuf...

  • Page 4

    6.

  • Page 5: 1. Introduction

    1. Introduction congratulations on purchasing vectorlite tm model vec120, an advanced design dual- bulb 3.000,000 candlepower spotlight and long lasting, soft cold cathode fluorescent lamp (ccfl) area/bug light. It uses two powerful proven-technology rechargeable, non-spillable sealed lead acid batt...

  • Page 6: 2. Additional Features

    2. Additional features • two powerful, prefocused, replaceable quartz halogen bulbs in spotlight. • ccfl area/bug light provides up to 48 hours of continuous operation. • ccfl area/bug light flips up for good area light distribution; down for bug light use. • three-position slide switch selects sing...

  • Page 7: Warnings:

    5 warnings: do not allow bare wires or connectors to contact each other dangerous sparking can occur - note which wires are on the battery terminals 6. Note polarity of battery. Note which wire is on which terminal. 7. Disconnect the wires from the battery and set the battery aside. 8. Connect the r...

  • Page 8: Replacing The Batteries

    4 14. Place the reflector in position in the body of the spotlight. 15. Replace the rubber ring in the groove around the perimeter of the reflector. 16. Replace glass and retainer so that the screw holes are aligned. 17. Secure retainer with two phillips screws. 18. Replace rubber bezel by sliding f...

  • Page 9: Recharge Adapter

    4. Charging the vectorlite using the ac recharge adapter note: this unit is shipped in a partially charged state. Initially charge unit using the ac charger. To check the battery level, press the battery status pushbutton (figure 2). Charge until battery status displays green led lights when the bat...

  • Page 10: Warning:

    2 5. Charging and powering the vectorlite using the dc recharge adapter the vec120 can be simultaneously charged and operated from a12 volt dc source. Make sure the 12 volt source can supply at ;least 15 amperes of current if the spotlight is to be operated while the batteries are being charged. To ...

  • Page 11

    3 to replace either or both h3 type 12 volt bulbs, you will need a small phillips type screwdriver and a replacement bulb (or bulbs) vector part vec190. Bulb life can be shortened by installing a bulb with dirt or fingerprints on it. The bulb can be wiped clean with cloth moistened with alcohol. Dur...