Vector 0 Owner's Manual & Warranty Information - Recharge Adapter
4. CHARGING THE VECTORLITE USING THE AC
RECHARGE ADAPTER
NOTE:
This unit is shipped in a partially charged state. Initially charge unit using the
AC charger. To check the battery level, press the Battery Status Pushbutton
(Figure 2). Charge until Battery Status Displays green LED lights when the
Battery Status Display Pushbutton is pressed. Charge after each use. See
Figure3A AC/DC Recharge Adapter.
IMPORTANT: DO NOT TURN ON ANY LAMPS OR OPERATE ANY DC APPLIANCES
THROUGH THE SPOTLIGHTS ACCESSORY OUTLET WHEN THE AC/DC
RECHARGE ADAPTER IS CHARGING THE UNIT.
1. Make sure all lamps and connected appliances are turned OFF
2. Locate the Recharge Port on the rear of the spotlight (see figure 2).
3. Connect the AC charger to a 110 VAC, 60 Hz power source.
4. Plug the AC charger’s barrel connecter into the AC Recharge Port.
5. Recharge for 10 hours maximum or until the green LED lights when the battery Status
Display Pushbutton is pressed.
6. After recharge, disconnect the Adapter from the external charging source then dis-
connect barrel connector from the Recharge Port.
7. After AC recharge, wait 5 minutes before using spotlight.
1