Vector 0 Owner's Manual & Warranty Information - Replacing The Batteries
4
14. Place the reflector in position in the body of the spotlight.
15. Replace the rubber ring in the groove around the perimeter of the reflector.
16. Replace glass and Retainer so that the screw holes are aligned.
17. Secure Retainer with two Phillips screws.
18. Replace Rubber Bezel by sliding forward to the front of the spotlight.
19. Operate switchs to ensure proper operation of spotlight.
REPLACING THE BATTERIES
The rechargeable sealed Lead Acid batteries have a life of several years, if recharged
promptly after each use. When the fully charged batteries only provide about 10 min-
utes or less of spotlight operation, they should be replaced with new batteries. To
replace the batteries, you will need the Phillips type screwdriver and replacement bat-
teries Vector Part VEC191. The batteries are in compartments referred to as upper and
lower. Because of spotlight construction, there are two procedures; upper battery
replacement and lower battery replacement. Both batteries are wired in series so they
should be replaced at the same time. DO NOT MIX BATTERY TYPES OR NEW AND
OLD BATTERIES.
See Figure 5
The upper battery can be replaced by doing the following:
1. Remove the six Phillips screws (clockwise) that fasten the plastic end cap. See
Figure2 for locations.
3. Remove the upper end cap from the body.
4. Note the battery can slide out of the body so keep the body level.
5. The battery terminals are attached to two wires. These wires must be disconnected
from the terminals of the battery.
Lower Battery
Compartment
(Cover Removed)
Upper Battery
Compartment
(Cover Removed)