Vega VEGAFLEX 82 Quick Setup Manual - page 15
15
5 Set up with the display and adjustment module
VEGAFLEX 82 • 4 … 20 mA/HART - four-wire
47593-EN-140324
1
2
Fig. 11: Insertion of the display and adjustment module into the double chamber
housing
1 In the electronics compartment
2 Intheconnectioncompartment(withEx-d-iaversionnotpossible)
Note:
Ifyouintendtoretrofittheinstrumentwithadisplayandadjustment
module for continuous measured value indication, a higher cover with
an inspection glass is required.
5.2 Parameter adjustment - Quick setup
To quickly and easily adapt the sensor to the application, select
the menu item "Quick setup" in the start graphic on the display and
adjustment module.
Youcanfind"Extendedadjustment"inthenextsub-chapter.
Measurement loop name
Inthefirstmenuitemyoucanassignasuitablemeasurementloop
name.Youcanenteranamewithmax.19characters.
Type of medium
Inthenextmenuitemyoucanseewhichtypeofmediumtheinstru-
ment is suitable for. If your instrument is only suitable for a certain
medium, this menu item is not visible.
Application
In this menu item, you can select the application. You can choose
between level measurement and interface measurement. You can
Quick setup
General information