Vega VEGASWING 66 Safety Manual - 5 Setup
9
5 Setup
VEGASWING 66 • Two-wire (8/16 mA)
45309-EN-130722
5 Setup
5.1 General information
Take note of the mounting and installation instructions of the operating
instructions manual.
5.2 Instrument parameter adjustment
The following adjustment elements are used to parameterize the
safety function:
•
Slide switch for changeover of the mode (min./max.)
•
Slide switch for changeover of the sensitivity
The function of the adjustment elements is described in the operating
instructions manual.
When operating with a signal conditioning instrument VEGATOR 636
or VEGATOR series 100 max. mode must be adjusted on the sen-
sor. The selection of the mode is carried out on the signal condition-
ing instrument.
During parameter adjustment, the safety function must be considered
as unreliable!
If necessary, you must take other measures to maintain the safety
function.
The sensor must be protected against inadvertent or unauthorized
modification!
Mounting and installation
Adjustment elements
Operation with a signal
conditioning instrument
Instructions