Velleman CAMCOLD5 Manual - page 5
CAMCOLD5
- 5 -
VELLEMAN
Example: Setting preset 15 to camera n° 5.
o
Press 5 and then press the CAM key to select the camera.
o
Move the P/T and the lens to the desired position.
o
Press the F1 key.
o
Press 8.
o
Press 15.
o
Press PRE to confirm your selection.
d.
Running the Preset
•
Select the desired camera number.
•
Define the preset (1 - 32). The default preset is 1.
•
Press the CALL key. The corresponding preset will be displayed on the screen.
Example: Setting camera n° 3 to preset 6.
o
Press 3.
o
Press the CAM key.
o
Press 6.
o
Press the CALL key.
o
Preset 6 of camera n° will be displayed.
e.
Pausing a Running Preset
•
Select the desired camera ID (1 – 63).
•
Press the HOLD key or tilt the joystick. The auto running preset will be paused.
Example: Pausing the preset of camera n° 4.
o
Press 4.
o
Press the CAM key.
o
Press HOLD or tilt the joystick. The preset of camera 4 will be paused.
8. Troubleshooting
Problem
Possible Cause
Solution
Wrong connection.
Check the connection.
The camera does not react when
connected to a power supply.
Power deficiency.
Check the power supply.
Wrong camera ID or baud rate.
Reset the camera ID or baud rate.
Wrong protocol.
Reset the protocol.
Light and image cannot be
controlled.
Wrong RS485 terminator setting.
Reset the RS485 terminator setting.
Non-compatible protocol.
Reset the DIP setting.
Wrong camera ID.
Reset the camera ID.
Power deficiency.
Check the power supply.
The camera cannot be controlled or
is moving erratically.
Wrong RS485 terminator setting.
Reset the RS485 terminator setting.
Wrong zoom setting.
Reset the zoom setting.
Fluctuating image.
Power deficiency.
Check the power supply.
Focus is manually set.
Run a preset or set the camera.
Dimmed image.
Dirty lens.
Clean the lens.