Velleman CAMCOLVC13 User Manual - page 5
CAMCOLVC13
Rev.
01
23.11.2010
©Velleman
nv
5
5.
Overview
Refer to the illustrations on page
2
of this manual.
1
Camera Lens
Clean the lens by soft dry cloth before usage
2
LED Light
2 Powerful LED to light/flash during low light
situations.
3
Microphone
Advanced sensitivity microphone to record audio
4
Power button + LED
Press
to turn on/off the camera
5
Live Record
Press
to record live videos or stop recording.
6
Snapshot
Press
to take single JPG photos
7
LED Button
Press
to turn on/ off LED light
8
LED Flash
Press
to flash LED light or stop flashing LED
9
Open
Push
to open the casing
10
Wrist Strap Hook
Attach wrist strap (included)
11
Mount Base
To support brackets and straps
12
Battery compartment Holds 2 rechargeable lithium batteries.
13
USB Port
Plug in USB cable to upload data
14
Micro SD Slot
Insert Micro SD card (up to 32 GB supported)
6.
Use
Refer to the illustrations on pages
2
and
3
of this manual.
Charging
•
Open the housing. To do this, press the open button
[9]
and gently slide the
housing open towards the back. Insert batteries (refer to
§8
)
•
Connect the USB-port
[13]
to a PC using the included cable. The LED
[4]
turns
red. The batteries are now being charged. Charging via PC might take from 8 to
12 hours; via an adaptor charging will take ±4h. Make sure batteries are
sufficiently charged before use.
Setting date/time
•
Open the housing.
•
Insert a micro SD card (not incl.) into the card slot
[14]
. Refer to the indication
next to the slot for the right direction. Only use a new card from a reliable
brand. Approximate recording times:
HD 1280x720 (30FPS)
2GB 4GB 8GB 16GB
32GB
Recording
Time
(Hours) 1 2 4 8 16
Note:
preferably use an empty formatted card to avoid recording problems.
•
Press the power button
[4]
shortly. After ±10s a blue LED under the power
button starts flashing. Press the live record button
[5]
to put the camera in
standby mode
.
•
Connect the USB-port
[13]
to a PC using the included cable. The LED turns red
and the camera now acts as a removable hard disk.
•
To set date and time, locate the program
720Ptime.exe
on the included