Velleman DK-9350 User Manual - page 26
A) Enter Programming Mode with Master Code (Exit-Factory Master Code: 0 0 0 0)
Entry of Master Code Confirm Comments
Set system to Programming Mode
NOTE: Factory has put a master code
into the keypad before exit-factory, owner may take it
for first me use.
B) System Refreshing to Single User Mode – Installer Programming
(Default: 8 9 0 0, Single-user mode)
Refresh Code Confirm Comments
Clear all previously stored data and set keypad back to default values except
Master Code
C) Code Entries – User Programming
1) Recording Master Code and User Codes – User Programming (No Default Codes)
Loca ons Entry of Codes Confirm Comments
4 digits fixed
Owner’s Master Code for se ng system to programming mode
4 digits fixed
User Code for opera ng Output 1
4 digits fixed
User Code for opera ng Output 2
Programming Summary Chart for “Single-User Mode”
SET KEYPAD TO SINGLE USER MODE (to whom it may require)
This keypad also consists of a simplified version so ware for code entry. It is single user mode for
those users only need one user code for each output and execu ng each of the special func ons.
Once the keypad is in single user mode, there is no User ID required for the codes, just simply enter
the code to each Loca ons directly.
Single user mode is prepared for those users who need simple func on and use the default values
for their keypad only. Please ignore this sec on if it is not suitable for your applica on.
Important Notes:
● All user codes and master code must be 4 digits. The codes of more than 4 digits will be invalid.
● Change the master code to 4 digits before refreshing the keypad to single user mode. Otherwise,
refreshing will be refused.
● Refreshing takes 2-3 seconds to complete. Do not enter any code during refreshing un l 2
confirma on beeps are heard.
● The keypad will be in auto code entry mode in default a er it is refreshed to single user mode.
● The keypad can be changed back to standard mul -user mode with the system refreshing code 8 9 0 1.
● Single user mode simplifies the procedures for code entry only. All programming procedures for
other features are exactly the same like in mul -user mode and not affected.
● See summary chart for the “Single-User Mode” programming procedures.
26