Velleman HAM263D User Manual - page 13

HAM263D 

00 (10/10/2008)                                                    

VELLEMAN 

13

•  show the faulty zone(s) during disarmed condition with user code 

•  arm system instantly without delay 

•  clear the alarm memory of the whole system or only specific sections 

•  initiate dynamic battery test at anytime during disarmed mode 

•  initiate a 5-second operation of both timing and latch output relays to test the connected 

siren/strobe light 

•  system code for direct access to programming mode in case the master code is forgotten 

•  fully Compatible with HAM263D alarm systems 

•  up to 4 keypads can be connected to the alarm system (HAM263D) 

•  extra keypads have the exact same functionality  as the master keypad 

•  simply connect extra keypads in parallel with the master keypad 

•  long connection distance possible, up to 500 metres 

5.3  Installation 

•  This keypad should be installed and serviced by a qualified person only. 

•  Choose an easily accessible location where the keypad is protected from harsh environmental 

conditions such as rain and bright sunlight, and away from heat producing devices. 

•  Have a qualified person installing the electrical leads (4) that are necessary for the connection of 

the keypad to the master control unit.  

•  Remove the keypad from the mounting frame by removing the screw at the bottom and pulling 

gently forward. 

•  Mount the mounting frame over the leads coming from the master control unit. Do not damage 

the leads when doing this. 

•  Remove the back cover of the keypad by removing the screws at the four corners. 

•  Make sure there is no power on the leads. Connect the leads to the connector block in the keypad 

as indicated on the PCB. 

•  It is also possible to install a tamper switch (not included). 

•  Re-mount the back cover with the 4 screws. 

•  Place the keypad back in the mounting frame. Make sure the cabling is not damaged in the 

process. Remount the screw at the bottom. 

•  Apply power to the leads (via the master control unit). 

•  There are no user-serviceable parts. Contact your dealer for spare parts if necessary. 

5.4  Keypad description 

A. General status LEDs 

B. Zone status LEDs  

C. Control key buttons