Velleman HAM263D User Manual - page 16
HAM263D
00 (10/10/2008)
VELLEMAN
16
• Format:
XXyyyyyy#
XX =
11
USER CODE 1 for arm/disarm control of part. 1
12
USER CODE 2 for arm/disarm control of part. 2
13
USER CODE 3 for arm/disarm control of the
whole system (partition 1 and 2)
yyyyyy =
4 to 6 digits
# = validation
e. Memorize frequently bypassed zones (“HOME” mode)
• HOME mode is only available for use with USER CODE 3 (whole system). However, partitions
can be bypassed by bypassing the zones within the partition one by one.
• Zone 8 (24 hour zone) is excluded from use in HOME mode
• Format:
HOMEyyyyyy#
HOME
Press HOME button on keypad
yyyyyy =
List of zones to be enabled, sequential e.g. 245 to
bypass zones 2, 4 and 5
# = validation
• To use the home mode, simply type USER CODE 3,
and
; all programmed zones will
automatically be bypassed.
f. Keypad audible notification set-up
• Some audible notification can be passed on to the keypad. This is the case for the exit and entry
delay, after an alarm condition and for each key button press.
• Alarm conditions concerning battery low or AC power failure conditions are always ON.
• Passing these notifications through to the keypad will not affect the beep settings on the master
control unit.
• Note that confirmation beeps from the
-button and
-button are always enabled.
14yyyy#
14
master code
yyyy =
4 digits: 0=beep disabled, 1=beep enabled (default)
digit 1 Beep for exit delay
digit 2 Beep for entry delay
digit 3 Beep after alarm condition
digit 4 Beep after each key button press
# = validation
g. Alarm detection response time
•
The default zone response time is set to 500ms. This setting can be adjusted independently per
zone, depending on the conditions in that zone.
•
The 8 digit code represents the 8 protection zones. The first digit is zone 1 and the last digit is
zone 8. By putting the timing codes into the specific digit to independently the desired response
time can be set.
15yyyyyyyy#
14
master code
yyyyyyyy = 8 digits, default setting = 3
1 25
ms
2 250
ms
3 500
ms
4 750
ms
# = validation
h. Reset system to default
•
To reset the system to its default values, enter code 2100#.
•
Except for the master code, all other values will be cleared or set to their default.