Velodyne SUBCONTRACTOR SC-600 Amplifier User Manual - page 16
www.velodyne.com
10 - Subcontractor Series User’s Manual
SELECT ING ThE SUBWOOFER TO BE CONTROLLED
Your SC-600D amplifier can control the Velodyne SC-600 Series subwoofers as well as generic passive
subwoofers.Specialinternalsoftwaresettingsaredesignedtomaximizeperformanceandreliabilitydepending
onthemodelofsubwooferbeingcontrolled,soitisimportanttomatchtheSC-600Damplifierwiththesubwoofer
itiscontrolling.TheSC-600DamplifiercomeswithadefaultsettingfortheSC-600IWsubwoofer.Whenthe
unitisfirstpoweredup,themodelbeingcontrolledisdisplayedfortwosecondsonthenumericLEDbeforethe
display reverts to the volume setting. The subwoofer to be controlled is shown as follows:
Note:BoththeIFandtheICsettingscontroltheSC-600In-Floor/In-Ceiling(IF/IC)subwooferandhaveidentical
internal settings.
Tochangethesubwoofertobecontrolled,firstpowerdowntheamplifierusingthemainpowerswitchonthe
back panel (Do noT use the power button on the front panel). Then, turn the switch on while depressing any
of the buttons on the front panel (crossover up or down, or volume up or down). The unit will show the model
it is currently controlling. To change the model, simply push the crossover up or crossover down buttons and
the model changes on the leD display. once the desired model is seen on the leD display, simply release the
button. you don’t need to do anything else - the model to be controlled is automatically stored in the SC-600D
amp’s memory. To exit model selection mode, use the main power switch on the back panel to power down
and power up the unit. you should see the model you selected for two seconds on the leD display before the
display reverts to the volume.
Note:TheSC-600Damplifiercancontrolonlyonesubwooferatatime,eithertheSC-600IWorSC-600IF/IC.