Velodyne SUBCONTRACTOR SC-600 Amplifier User Manual - Setup Checklist
www.velodyne.com
2 - Subcontractor Series User’s Manual
SC-600 IW, SC-600 IF/IC SUBWOOFERS
SC-600 IW (In-Wall):
- Two high excursion 6.5” active drivers, two 12.5” x 3” oval passive radiators with ribbed rubber surround
- High-excursionrubbersurroundsonbothactiveandpassivedrivers
- 2” 4 layer copper
- FrequencyResponse:30-120Hz(+/-3dB)
- 4 ohm impedance
SC-600 IF/IC (In-Floor/In-Ceiling):
- 12” (9.7” piston diameter) subwoofer
- 2.5” 4 layer copper
- Oversizedspiderforlinearityathighexcursion
- High-excursionrubbersurround
- FrequencyResponse:25-120Hz(+/-3dB)
- 4 ohm impedance
Note: TheSC-600IWandtheSC-600IF/ICmustbedrivenwitheithertheSC-600DortheSC-602amplifier.
Use of any other power source voids the warranty.
SETUp ChECkLIST
Besuretodothefollowingtoensurethebestperformancefromyoursubwoofer(s):
Ifpossible,optimizetheplacementofthesubwoofer(s)inthelisteningarea.Seepage10oftheUser’s
manual.
Install and wire the subwoofer per the instructions on pages 3 - 8.
Select the proper model per the instructions on page 10.
Select the proper volume level. See page 4.
Besurethelowpasscrossoverissetcorrectly.Seepages8-9.
BesuretoequalizethesubwooferusingthemicrophoneandAuto-EQfeature.Seepage11.
Besuretosetthephasecontrolontheremote.Seepage11.
Select the correct preset for the source material. See page 13.
your new velodyne subwoofer system provides for a number of installation options. Read all the installation
information below in order to determine which installation option is best for your system. Remember to perform
allinstallationprocedureswithsystempowerturnedoff.
Note: For proper setup and installation of the SC-600 IW (In-Wall) subwoofer, please refer to the SC-600 IW
QuickInstallGuide.