Veloteq CF 6000 User Manual - page 12
-11-
How to operate the DM 6000
How to exercise on the DM 6000
To step onto the magnetic elliptical bike, hold
the handlebars and step onto the pedal that is
in the lowest position. Then step onto the
other pedal. Push the pedals until they begin
to move with a continuous motion. (Note: The
crank can turn in either direction; it is
recommended that you turn the crank in the
direction shown below; however, to give
variety to your exercise, you may choose to
turn the crank in the opposite direction.)
To dismount the magnetic elliptical bike, allow
the pedals to slowly come to a stop.
CAUTION: The magnetic elliptical bike does
not have a freewheel; the pedals will continue
to move until the flywheel stops. When the
pedals are stationary, step off the highest
pedal first. Then step off the lowest pedal.
How to operate the Heart Rate Sensors
To measure your pulse, stop pedaling and
place both hands on the pulse sensors as
shown. Grip for five to ten seconds, the heart
rate symbol will flash and your heart rate will
then be shown. Continue to grip the sensors
for a further fifteen seconds to obtain the
most accurate reading If the displayed pulse
appears too be to high or too low, or if your
pulse is not displayed, lift your hands off the
sensor and allow the display to reset. Grip
again on the sensors as described above. Try
the sensors several times until you become
familiar with it.