Velux KLI 110 Instructions Manual - page 4
VELUX 7
6 VELUX
+
+
Key
prg
Led
set-up and programming
note: Do not fix control keypad KLI 110 to the wall until set-up and
programming have been completed and it has been verified that the
relevant products can be operated from the proposed position.
Remove front section and insert the two batteries supplied as shown.
On the back of the front section, the keypad is equipped with two but-
tons
c
, KEY and PRG, and a light-emitting diode (LED)
d
to be used for
set-up and programming. During set-up and programming, the keypad
must be within RF range of the products to be operated.
security key
Each product has a security key ensuring that external control devices
cannot communicate with your system. A common security key is
created automatically during the registration process ensuring that all
products in the system share the same security key.
+
+
-
-
operation
Keys for operating the product
a
OPEN/UP or CLOSE/DOWN
short key pressure: Product will travel to maximum top or bottom
position.
Long key pressure: Product will travel only until the key is released.
note: If several electrical products are connected to a control unit
KLC 500, only one of the products (random) can be operated in this way.
stop key
b
Product stops.
b
a
d
c