Venmar ISPIRA IU600ES SERIES Installation Instructions Manual - 11. Care
11
11. CARE
(
CONT
'
D
)
G
LASS
PANEL
Hot water with mild soap or glass cleaner is all that is usually needed.
When using mild soap, rinse with clear water. Wipe dry with a clean, soft cloth to avoid water marks.
Avoid when choosing a detergent:
- Any cleaners that contain
bleach.
They will attack stainless steel.
- Any products containing
chloride, fluoride, iodide, bromide.
They will deteriorate surfaces
rapidly.
- Any combustible products used for cleaning such as
acetone, alcohol, ether, benzol
, etc. They
are highly explosive and should never be used close to a range.
12. OPERATION
Always turn your hood on before you begin cooking to establish an air flow in the kitchen. Let the
blower run for a few minutes to clear the air after you turn off the range.
HC0052
A
B
C
D
A. D
ELAY
B
UTTON
/C
ONTROL
L
OCK
(D
OUBLE
F
UNCTION
B
UTTON
):
i. When a blower speed is selected, press this button to activate the delay function. The
delay button will light to its high intensity, then to its mid intensity to indicate this function
is activated; the selected blower speed button will alternate every 2 seconds from its high
intensity to its mid intensity. The blower will continue to operate for 5 minutes and will
stop automatically. Selecting an other speed while the delay function is activated will not
deactivate the function or reset the timer. To cancel the delay function, press the delay
button once again, or press the selected speed button which will also turn the blower off.
ii. When blower is off, it is possible to lock the control interface in order to clean the glass
panel.
To lock the control interface: Press and hold the button for 2 seconds. The button will light
to its high intensity and flash three times, it will then stay on its mid intensity to indicate that
the control interface is locked.
To unlock the control interface: Press and hold the button for 2 seconds. The button will light
to its high intensity and flash 3 times, it will then fade out to its low intensity to indicate that
the control interface is unlocked.
B. S
PEED
S
ELECTION
B
UTTONS
:
Press the button corresponding to the desired blower speed (from
1
for low speed to
4
for
high speed). The chosen speed button will light to its high intensity then fade to its mid
intensity. To turn off the blower, press once more on the corresponding blower speed button;
the button light will fade to its low intensity.
NOTE: When blower is off, pressing on blower speed
1
button will cause the blower to start
on second speed for a very short lapse of time, and then resume on speed
1
.