Venmar ISPIRA IU600ES SERIES Installation Instructions Manual - Table of Contents
3
TABLE OF CONTENTS
1. I
NSTALL
DUCTWORK
.................................................................................................. 3-4
2. P
REPARE
INSTALLATION
............................................................................................. 4-5
3. P
REPARE
THE
HOOD
................................................................................................. 5-6
4. I
NSTALL
GLASS
PANEL
(
WG
MODELS
ONLY
) ........................................................................ 6
5. I
NSTALL
THE
ADAPTER
/
DAMPER
....................................................................................7-8
6. I
NSTALL
THE
HOOD
...................................................................................................... 8
7. C
ONNECT
WIRING
....................................................................................................... 9
8. R
EINSTALL
BLOWER
WHEEL
AND
BOTTOM
PANEL
................................................................ 9
9. R
EINSTALL
HYBRID
FILTERS
......................................................................................... 10
10. L
ED
LIGHTING
........................................................................................................... 10
11. C
ARE
.................................................................................................................10-11
12. O
PERATION
.......................................................................................................... 11-12
13. W
IRING
DIAGRAM
...................................................................................................... 13
14. S
ERVICE
PARTS
................................................................................................... 14-15
15. W
ARRANTY
............................................................................................................. 16
1. INSTALL
DUCTWORK
Plan where and how the ductwork will be installed.
The ducting from this fan to the outside of the building has a strong effect on the air flow, noise
and energy use of the fan. Use the shortest, straightest duct routing possible for best performance,
and avoid installing the fan with smaller ducts than recommended. Insulation around the ducts can
reduce energy loss and inhibit mold growth. Fans installed with existing ducts may not achieve their
rated airflow. Refer to the table next page to help you plan the most efficient installation.
Install wall or roof cap; once done, ensure there is no leak in house insulation. Connect metal
ductwork to cap and work back towards the hood location. If 6” round ducts are installed, use a
3¼” x 10” to 6” transition positionned, if possible, 18” away from the adapter/damper. Use 2” metal
foil duct tape to seal the joints.
We recommend to install the hood at a minimum distance of 24” from an electric range and
of 30” from a gas range.
Distances over 30” are at the installer and users discretion.
H
OOD
3¼"
X
10"
DUCT
R
OOF
CAP
W
ALL
CAP
HH0142A
24"
MINIMUM
ABOVE
COOKING
SURFACE
(30"
FOR
GAS
RANGE
)
3¼"
X
10"
A
DAPTER
/D
AMPER
H
OOD
6" R
OUND
DUCT
R
OOF
CAP
W
ALL
CAP
3¼"
X
10"
TO
6"
R
OUND
TRANSITION
HH0222A
3¼"
X
10"
A
DAPTER
/D
AMPER
24"
MINIMUM
ABOVE
COOKING
SURFACE
(30"
FOR
GAS
RANGE
)