VENOM Pro2 Operating manual - page 10
7
667
The Charger will use the default values upon being powered up for the first time.
The Screen displays the following information in sequence and the user can change
the values of each parameter
To change the default values, press the Start/Enter key once. The value to be
adjusted will blink indicating it can be edited. Use the Inc/Dec keys to adjust the
value to the desired setting, then press the Start/Enter key once to save your
changes for that value.
The screen will show the nominal voltage of
the three types of Lithium batteries; LiFe (3.3V),
Lilo (3.6V), and LiPo (3.7V). It is very important
to make sure you choose the correct type of
battery during set up. Refer to the battery’s
owner manual for reference if needed. Failure
to choose the correct battery type can cause
damage to the battery, charger and will void all
warranties.
The charger will recognize the cell count of
Lithium batteries automatically at the beginning
of the charge or discharge cycle and compare
it to the settings selected. If a voltage has been
selected that is different from the voltage it
detects, an alarm will sound.
Over discharged batteries MAY be detected as a lower cell count pack. Always
confirm your setting before starting a charge sequence. Using the “CHK TIME”
parameter in your LiPo/Lilo/LiFe settings can allow you to delay detection in an
attempt to bring a dead battery back to life. YOU MUST USE EXTREME CAUTION
WHEN DELAYING CELL DETECTION. A 10 minute delay is suggested for larger mAh
packs, but small capacity batteries may finish charging/discharging before the 10
minute mark which could result in catastrophic failure of the battery. If there are any
doubts on how to use this feature, please contact Venom directly.
5. INITIAL USER PARAMETER SET UP