VENOM Pro2 Operating manual - page 16
13
667
Use these programs only when charging a NiMH (Nickel-Metal-Hydride)or NiCd
(Nickel-Cadmium) battery. To alter the value on the display, press the START/ENTER
key. The charge current can now be altered by using the increase/decrease buttons.
The value will be saved by pressing Start/Enter key once. To start the process, press
and hold the START/ENTER button for more than 3 seconds.
7.1 CHARGING NICD/NIMH BATTERIES
With NiMH and NiCD packs, you do not have to indicate to
the charger how many cells are in the pack. In auto “AUT”
mode, simply set your charge current (no more than a 1C
rating.), press START/ENTER for 3 seconds and the charge
process will begin. In manual “MAN” mode, it will charge
the battery with the charge current you set at the display.
Each mode can be switched by pressing increase/decrease
button simultaneously when the current field is blinking.
The screen will display the current state of charging. To
stop the process, press the Batt type/Stop key once. An
audible sound will indicate you have ended of process.
7.2 DISCHARGING NICD/NIMH BATTERIES
Set discharge current on the left and final voltage on the
right. The discharge current ranges from 0.1 to 1.0A and the
final voltage ranges from 0.1 to 25.0V). Refer to your battery’s
specifications to determine optimal discharge current and
final voltage. To start the process, press START/ENTER key
for more than 3 seconds.
The screen will display the current state of discharge. You
can alter the discharge current by pressing START/ENTER
key during the process. Once you change the current value,
store it by pressing START/ENTER button again. To stop
discharging press Batt type/Stop key once. An audible sound
will indicate the process has ended.
7. NIMH/NICD BATTERY PROGRAM