Vent-Axia 403368 Operating Instructions Manual - page 6
5
Air Speed Adjustment
The dryer air speed can be adjusted. However, when lowering the motor speed, the drying
time will increase also.
The ability of this function will be dependent on the needs of the owner.
The factory setting for dryer’s motor speed is set at its highest speed. See
below for how to adjust the dryer speed:
1.
Use key (supplied) to unlock and withdraw the tray.
(fig. 1).
2. Use flat blade screwdriver, gently turn adjustment potentiometer
(fig. 2)
shaft clock-wise [CW] to
increase power to maximum (shaft will hard stop; DO NOT OVERTURN!). Turn tool gently
CCW to reduce power as required (shaft will hard stop; DO NOT OVERTURN!). Note that at
minimum power the unit may not start if low line Voltage condition exists.
3.
Insert the tray back and lock the security screw.
Reduce power
Increase power
Potentiometer
OFF/ON
Reduce
(fig. 1)
(fig. 2)
Heater Element Switch ON/ OFF
The Dryer has been designed with a heater switch that can turn the heater ON/OFF. The heater
switch doesn't affect the drying time. In cold conditions, it may be more comfortable if it is on
when drying hands. However, it will save a third of the energy if it is off. This function can be
adjusted depending on the needs of the owner. The factory setting for the heater will be on.
See below for how to turn the heater ON/OFF.
1.
Use key (supplied) to unlock and withdraw the tray.
(fig. 1).
2.
Switch it to the right to turn ON. Switch it to the left to turn OFF (fig. 2).
3.
Insert the tray back and lock the security screw.
Switch
OFF/ON
Reduce
(fig. 1)
(fig. 2)