Vent-Axia LoWatt T-SERIES Installation And Operating Instructions Manual - page 5
5
INSTALLATION
F1
From the inside: Fit the spigot through the fixing hole, with the connector socket cut out at the
top. Ensure that the rubber seal is correctly located over the four lugs on the spigot.
F2i WINDOW
From outside: Place the outdoor grille assembly with the louvres slanting downwards, and the
Vent-Axia logo at the top of the grille, over the projecting spigot.
F2ii ROOF
From outside: Place the exterior roof cowl over the projecting spigot. Use a suitable sealing
compound between the cowl and the glass/or roof plate.
F3i/ ii Secure the outdoor grille or roof cowl, using the fixing screws supplied. Then tighten the
screws in turn to give an even pressure around the hole.
F4a/ b Refit the motor body housing assembly and turn clockwise until the locking catch is engaged.
Take care not to trap the mains supply cable or the speed controller socket cable (wired version
only).
F5
Release the Power Supply/Receiver Unit locking catch and lower until the catch engages in the
lower position, fix the controller socket into position (wired version only).
F6
Lift the black rubber gasket on the Power Supply/Receiver Unit and switch the three-position
switch to the required running option, then replace the gasket seal.
F7
If a speed controller is being used refer to the relevant Speed Controller Fitting and Wiring
instructions.
F8
Refit the housing ensuring that no internal wires are trapped between the housing and base.
F9
Engage the two side catches. Tighten the two side catch screws.
F10 Replace the indoor grille with the louvres slanting upwards, with the Vent-Axia logo at the
bottom of the grille, and secure with the retaining screw.
F1
F2i
F2ii