Vent-Axia LoWatt T-SERIES Installation And Operating Instructions Manual - page 8
8
WIRING THE CONNECTOR SOCKET
•
Ensure that the supply (Voltage, Frequency and Phase) complies with the rating label.
•
This appliance must be earthed.
F11Remove the top cover from the connector socket by undoing the 2 retaining screws.
F12 Lift up lever and slide out top cover.
F13Loosen cable clamp screws and pass the cable through the clamp. (It may be necessary when
using some 3-core cables to reverse the cable clamp to ensure that the cable is securely
retained. For ease of wiring, the terminal block may be removed from the connector housing.
F14 Tighten cable clamp screws evenly, ensuring a secure grip on the outer sheath of the cable.
F15 Slide the top cover back on and secure with the 2 retaining screws.
F16 Fit connector socket and push down on the lever to lock it in position.
Fig 2 Using an On/Off switch: Connect the mains supply to the fan connector socket.
Fig 3 Auxiliary sensor switching: Connect the mains supply to the fan connector socket.
F11
F12
F13
F14
F15
F16
Fig. 2
(Wired version only)
Please refer also to the speed controller
fitting and wiring instructions.