Ventrac HE302 Operator's Manual And Parts List - Operational Controls
Operation - 14
OPERATIONAL CONTROLS
Operational Control Locations
Use the following images to help identify the locations
of operational controls. The letter next to each control
can be referenced to the list that follows these images.
A.
A
B
C
Primary SDLA Lever (power unit)
B. Secondary SDLA Lever (power unit)
C. Handle with Switch* (power unit equipped
with dual hydraulic auxiliary kit)
Primary SDLA Lever (A)
Pull the lever to the left to raise the power unit hitch
arms and the power bucket. Push the lever to the
right to lower the power unit hitch arms and the
power bucket. Float position is attained by pushing
the lever to the right until the float detent locks the
lever in place.
Secondary SDLA Lever (B)
Pull the lever to the left to roll the bucket back for
carrying material. Push the lever to the right to tip
the bucket forward and dump the load.
Handle With Switch (C)
The optional handle (dual hydraulic auxiliary kit) is
used to select which set of quick couplers is con-
trolled by the secondary SDLA lever. The secondary
SDLA lever operates the hydraulic couplers with red
and yellow indicators until the button on the handle
is depressed. Pressing this button switches the
secondary SDLA lever to control the operation of the
hydraulic couplers with white and black indicators.
This allows operation of both the power bucket and
the optional grapple kit.
Pull the lever to the left to tip the bucket back for
carrying material. Push the lever to the right to tip
the bucket forward and dump the load.
Press the button on the handle and push the second-
ary SDLA lever to the right to open the grapple jaws.
Press the button on the handle and pull the second-
ary SDLA lever to the left to close the grapple jaws.
Release the button to return to normal operation.
* This feature is required to operate a power bucket that
is equipped with an optional grapple kit.