Ventrac HE302 Operator's Manual And Parts List - Service
Service - 17
SERVICE
Cleaning and General Maintenance
For best results, and to maintain the finish of the
power bucket, clean or wash the power bucket after
each use to remove dirt, mud, stones, mulch, or
other debris.
Lubrication Locations
Lubrication is required at the following locations
using a lithium complex NGLI #2 grease. Refer to
the maintenance schedule for service intervals and
amount of grease.
Cylinder Ends & Bucket Pivot (Right & Left Sides)
Cylinder Ends & Bushings (Optional Grapple)
Storage
Preparing the Power Bucket for Storage
1. Clean the power bucket.
2. Inspect for loose or missing hardware, damaged
components, or signs of wear.
3. Inspect safety decals. Replace any decals that
are faded, illegible, or missing.
4. Inspect hydraulic hoses and fittings to ensure
tight, leak free connections. Repair or replace
any damaged or wore components.
5. Apply grease to all grease points. Wipe off all
excess grease.
Removing the Power Bucket from Storage
Inspect, clean, and prepare the power bucket for use.
Optional Power Bucket Teeth Installation
1. Park the power unit and power bucket on a level
surface and raise the power bucket high enough
to place blocks underneath.
2. Place 4” blocks or other supports under the
power bucket and lower the bucket until it is
resting on the blocks.
3. Shut off the power unit’s engine, set the parking
brake, and remove the key from the ignition.
4. Start at one side of the power bucket, and install
the sets of teeth (A) onto the front cutting edge
of the power bucket. The 30” power bucket uses
three sets of teeth and the 48” power bucket
uses four sets of teeth.
5.
A
Secure each set to the power bucket using 2)
3/8” x 1-1/4” carriage bolts inserted up through
the tooth and bucket. Secure with 2) 3/8” flange
nuts and torque to 31 ft-lbs (42 Nm).
Always set the parking brake, shut off power
unit engine, remove the ignition key, and ensure
all moving parts have come to a complete stop
before inspecting components or attempting any
repair or adjustment.
Attention
If any component requires replacement, use only
original Ventrac replacement parts.