Vents TwinFresh Comfo SA-50 User Manual - page 9
9
TwinFresh Comfo SА-50
Unit control with the buttons on the ventilating unit
To turn the ventilator on select one three ventilation modes and activate the second
or the third
speed.
To turn the ventilator off set the speed switch to the middle position
.
Use the ventilation mode switch to change the ventilation mode, fig. 7.
Remote control with a remote controller
In case of remote control set the switches on the ventilating unit to the middle position.
To turn the ventilator ON/OFF press the button
.
Press the button
to activate the Night mode, activation of the night mode is confirmed by a long sound signal. Press
the same button
to deactivate the Night mode, deactivation is confirmed by a short sound signal. When Night mode is
activated, the unit is turned to the first speed when the light is off.
Speed selection
First speed —
.
Second speed —
.
Third speed —
.
Operation modes
To change to Passive ventilation mode press the button
. In this mode ventilation is performed without a fan.
To change to Supply mode press the button
. In this mode the ventilation is performed at selected speed.
To change to Extract mode (exhaust mode by default) press the button
. In this mode air is extracted at selected speed.
To change to Heat Recovery mode press the button
. In this mode the fan operates 70 seconds in Supply mode and then
switches to Extract mode. Heat recovery is performed in this mode.
Humidity control
Humidity control is possible only in Heat Recovery mode.
To set the humidity threshold press the following buttons:
— 45%;
— 55%;
— 65%.
If the indoor humidity exceeds the set point, the unit is switched to the third speed. If the indoor humidity is within ±5% of the set
point, the unit operates at the second speed. If indoor humidity is below the set point, the unit switches to minimum speed. Press any speed
selection button to deactivate the humidity control.
HUMIDITy CONTROL IS POSSIBLE ONLy FROM THE REMOTE CONTROLLER!