VolantexRC Vector Series Owner's Manual - page 11
Rudder does not move
Rudder, linkage or servo damage
Replace or repair damaged parts and adjust con-
trols
Wire is damaged or connections are
loose
Do a check of wires and connections, connect
or replace as needed
Transmitter is not bound correctly or
the incorrect model was selected
Re-bind or select correct model in transmitter
BEC (Battery Elimination Circuit) of the
ESC is damaged
Replace ESC
ESC switch is off
Power on ESC switch
Controls reversed
Transmitter settings are reversed
Do the Control Direction Test and adjust controls
on transmitter appropriately
Motor or ESC overheats Blocked water cooler tubes
Clean or replace water tubes
Motor power pulses
then motor loses power
ESC uses default soft Low Voltage Cut -
off (LVC)
Recharge boat battery or replace battery that is
no longer performing
Weather conditions might be too cold
Postpone until weather is warmer
Battery is old, worn out or damaged
Replace battery
Battery C rating might be too small
Use recommended battery
© 2013 VolantexRC Co., Ltd.