VolantexRC Vector Series Owner's Manual - Rudder Installation
Boat Battery Pack(s) Installation
1. Roat the hatch on the hull cover in clockwise to unlock the hatch.
2. Open the hull cover.
3. Adhere loop tape (included) to the battery.
4. Secure the boat battery on the hook strip in the boat.
5. Secure the battery in the hull with the hook and loop
strap as shown.
3
5
4
Rudder Installation
1. Align the propeller with the drive dog on
the flex shaft, then install the propeller
using the included locknut.
2. Install the rudder horn to the rudder by
two screw.
3. Install the rudder to the rudder holder
and fix it by a bolt as show in the graphic.
4. Connect the cooling line to the fitting on
the top of the rudder.
5. Ensure the trim tab panel is either perpendicular to or parallel to the bottom
of the boat. If it’s needed to switch the angle of the panel, tie or release the
screw which is touch the panel to switch the angle.
2
3
1
2
5
4
Unlock
Lock
1
open
2
Antenna Tube Installation
1. Carefully feed the end of the receiver antenna through the grommet
inside the hull.
2. Pull the antenna wire out of the grommet towards the outside of the
boat, then slide the antenna through the antenna tube.
3. Insert the tube into the grommet, then fit the cap onto the tube.
4. Apply clear tape to the antenna, grommet and hull in the boat to
keep the antenna from moving.