VolantexRC Vector Series Owner's Manual - Check Lists
6
Check lists
Before Boating
• Install fully charged batteries in your boat and transmitter
• Connect the boat’s battery to the ESC
• Make sure the boat is bound to the transmitter (otherwise, bind the boat to the
transmitter using the included binding instructions)
• Make sure all linkages move freely on the boat
• Ensure the motor mount is secured to the hull so that the motor does not move
• Perform a Control Direction Test with the transmitter
• Adjust the steering rate on your transmitter as desired
• Find a safe and open boating area
• Plan a safe boating route for the water and wind conditions
After Boating
• Always power off the receiver before powering off the transmitter to maintain
control of the boat and to retain transmitter binding
• Disconnect the battery from the receiver and remove the batteries from the boat
• Fully dry the inside and outside of the boat, including the water cooling lines and
jackets around the motor and ESC. Remove the hatch and radio box cover before
storing your boat
• Repair any damage or wear to the boat.
• Lubricate the flex shaft
• Make note of lessons learned from the trimming of your boat, including water and
wind conditions
Tip: The hook and loop strips in the boat retain water. To dry them, press on them
with a dry cloth.
Battery Safety Precautions
IMPORTANT NOTE: Lithium Polymer (LiPo) batteries are significantly more
volatile than the alkaline , NiCd and NiMH batteries also used in RC applications.
All instructions and warnings must be followed exactly to prevent property damage
and/ or personal injury as mishandling of LiPo batteries can result in fire.By
handling, charging or using the included LiPo battery you assume all risks
associated with LiPo batteries. If you do not agree with these conditions, please
return your complete product in new, unused condition to the place of purchase
immediately. You must read the following safety instructions and warnings before
handling, charging or using the LiPo battery.