Vollara safe hearth User Manual - page 5
8
9
Auto-lock can prevent children from changing settings on the heater. It can be set with the unit either power on, to
prevent changes to the temperature or fan setting, or power off, to prevent turning the unit on. When locked, control
panel and remote control failed to function.
Press timer button either on the control panel or remote
control.
Indicator lights signal the length of the timer. to set the length of time, press the
timer button continuously until the indictor of desired length lights. timer will
begin immediately. timer can be set at a 2h-4h-6h-8h circulation. When all 4 lights
are off, that indicates the timer is not set.
Press temp up and temp Down buttons simultaneously and
hold for 3 seconds. unit is locked when abeep sounds. When
locked, control panel and remote control failed to function.
to release the Auto-lock feature, press temp up and temp
Down buttons simultaneously for 3 seconds. unit is unlocked
when a beep sounds. lock indication disappears. control panel
and remote control return to normal function.
SETTING THE TIMER
SETTING THE AUTO-LOCK
• to keep the heater clean, the outer shell may be cleaned with a soft cloth.
CAUTION: DO nOt let liquid enter the heater.
dO NOT put liquids inside the heater.
• DO nOt use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. this may cause
damage or deterioration to the surface of the heater.
• DO nOt immerse the heater in water.
• Wait until the unit is completely dry before use
Remote Control Care
When remote control will not be in use for a long period of time, remove the battery according to the following steps.
Air Filter Cleaning
NOTE: Always disconnect from power before removing filter for cleaning.
Air filter requires cleaning after every 3-6 months of use, or as needed. Please remove the filter following the steps below.
Once removed, flush and clean the filter with water, then allow to air-dry completely before reassembling.
MAINTENANCE
WARNING:
• turn off the power switch in the rear of the unit.
• unplug the unit and let it cool completely.
Unit Cleaning
Push battery cover lock up then pull cover out as indicated in the diagram above. When replacing the battery, positive side faces up.