Volvo 164 Owner's Manual - page 10
OPERATING INSTRUCTIONS
F Warning lamp, overdrive
The lamp gives a steady green light when
the overdrive is engaged. Concerning en-
gaging and disengaging overdrive, see
page 22.
H Parking brake warning light
(functions also as warning
light for both service
brake circuits)
This lights red when the parking brake is
applied and the ignition is on.
The light also functions as a warning light
should a failure arise in one of the brake
circuits. If the light goes on during driv-
i ng, the car should be driven without delay
to a workshop for a check on the brake
system. Observe due care when driving
under such conditions.
K Oil pressure warning light
This lights red when the engine oil pres-
sure is too low. When the ignition is
switched on, the light should go on and
then go out again when the engine starts.
Never start driving until the light goes out.
I f the light goes on during driving, stop the
engine and find out the reason for this. In
most cases it means that the oil level is
too low. After hard driving it may happen
that the warning light comes on when the
engine is idling. This is normal providing
it goes out again when engine speed is
i ncreased.
J Warning lamp, choke
The lamp gives a steady amber light when
the choke control is pulled out. Drive as
short a distance as possible with the
choke out.
Vehicles with the B 30 E engine do not
have this warning lamp.
L Mileometer
The mileometer shows the total distance
covered in miles. After 999999 miles it re-
turns to zero and starts to go round again.
M Speed warning indicator
The speed warning indicator
i s mounted on the speedo-
meter and consists of a manually adjust-
able sliding arrow. Its purpose is to remind
the driver of the particular maximum per-
missible speed in connection with speed
li mit regulations.
N Trip meter
The trip meter measures distances of up
to maximum 999 miles. The window fur-
thest to the right shows tenths of a mile
and is therefore useful for measuring short
distances.
0 Trip meter reset knob
The trip meter is set to zero by pushing
i n the knob.
9