Volvo 164 Owner's Manual - page 69
CONSUMER INFORMATION
Notes to lubricating chart
Note 1.
The wheel bearings are packed
at the factory with a special type of grease
i ntended to last the entire lifetime of the
bearings. In connection with such work-
shop operations involving uncovering the
wheel bearings, the bearings should be
cleaned and then lubricated with high-
class, durable grease according to the in-
structions in the service manual. Except on
the above occasion, subsequent adding or
changing of lubricant is not required.
The rear wheel bearings are lubricated, so
changed of lubricant is unnecessary. After
the bearings have been removed, however
they should be lightly greased with wheel
bearing grease.
Note 2.
Servo steering: Check that the oil
l evel in the servo steering oil container is
5-10 mm (5 1/6") above the level mask.
Use Automatic Transmission Fluid. Type A
or Dexron.
Note 3.
Check that the fluid reaches up
to the MAX mark. (For right-hand drive,
check also clutch fluid level.)
Note 4.
Lubricate the felt wick under the
rotor and fill a few drops of light engine
oil into the lubricating cup.
Note 5.
Check every 10 000 km (6000
miles) that the oil reaches up to the filler
plug. Concerning oil change, see page 44.
NOTE. The type of gearbox will decide the
type of lubricant to be used.
Note 6.
At every engine oil change check
that the oil level in the centre spindle of
the carburettors reaches up to about
' l4"
(6 mm) from the edge of the spindle. Use
Automatic Transmission Fluid (ATF).
Note 7.
Change the oil filter every 10 000
km (6 000 miles). See page 47.
Note 8.
Check the oil level when filling
the tank. Concerning oil changing, see
page 43.
Note 9.
Check every 10 000 km (6000
miles) that the oil reaches up to the filler
plug. Concerning lubricant for rear axle
with differential lock, see page 45.
68