1. DL manuals
  2. W Audio
  3. Recording Equipment
  4. CR-6
  5. User Manual

W Audio CR-6 User Manual

Other manuals for CR-6: User Manual

Summary of CR-6

  • Page 1

    Professional 19” rack mixer cr-6 user manual thank you for buying w audio product. To take full advantage of this product, please keep this manual and read the operating instructions carefully. Content z safety instruction ...………………………1 z rear panel ……..…………………….........3 z main features …....……….……...

  • Page 2

    Cr-6 professional 19” rack mixer user manual page 1/5 v-1 1. Safety instructions the lighting flash with arrowhead symbol, with in an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magni...

  • Page 3

    Cr-6 professional 19” rack mixer user manual page 2/5 v-1 3．precaution 1) all operating and other instructions should be followed before this product is connected and used. 2) make sure the mains power of the unit is turned off before installation. 3) make sure all the connectors are well connected ...

  • Page 4

    Cr-6 professional 19” rack mixer user manual page 3/5 v-1 5．rear panel 14) power switch – switch the unit on. 15) power supply input – to plug you power adapter in before switching on. 16) balanced zone b outputs- 1/4” stereo balanced trs 1/4” connectors controlled by the zone b knob. 17) balanced z...

  • Page 5

    Cr-6 professional 19” rack mixer user manual page 4/5 v-1 6．connections ( setup ) there are many options available for your particular needs and the diagram below is just one example for your reference. Make sure all knobs are at “ zero “ and all devices are off. First, connect all input sources; ne...

  • Page 6

    Cr-6 professional 19” rack mixer user manual page 5/5 v-1 7．specification 10k input impedance line 140mv rms sensitivity ( for 1.4v balanced output ) 10k input impedance unbalanced mic 1 1.5mv rms sensitivity ( for 1.4v balanced output); 60mv rms max input 10k input impedance inputs mic2/ mic3 1.5mv...