W Audio CR-6 User Manual - page 3
CR-6 PROFESSIONAL 19” RACK MIXER USER MANUAL PAGE 2/5 V-1
3.Precaution
1) All operating and other instructions should be followed before this product is connected and used.
2) Make sure the mains power of the unit is turned off before installation.
3) Make sure all the connectors are well connected in their indicated positions firmly. Use appropriate
cables throughout your system; quality cable makes a big difference in audio fidelity.
4) Never attempt to make any adjustments or repairs other than those described in this manual.
5) Always start with volume controls/ master controls on minimum.
6) Try to move gain controls slowly. Rapid adjustments could damage speakers.
7) If the mixer does not work properly, stop and disconnect it immediately. Do not attempt to repair it by
yourself, contact your dealer for service.
4.Front panel
1)Input gain knobs ( for six lines )- Control individual source levels.
2)On/off switches – Allow sound to be brought to the unit on each channel.
3)Zone assign – Determines which zone the audio is directed to. The A+B position sends channels audio to
both Zones.
4)Mic 1 Gain control – Controls the mic volume for the Neutrik combo connector on the front panel.
5)Mic EQ controls – Adjusts the Treble, Middle, Bass frequencies respectively of the mic audio.
6)Neutrik Combo Connector – Allows connection of either a 1/4” jack or an XLR plug.
7)Zone Knob – Controls the output level.
8) Mono/ Setreo- Sets the mode for the output sound.
9) Panning – Controls the mix of stereo audio available from the channel. Moved to the left only the left
speakers will be heard, or to the right for the right speakers.
10) Level Indicator – Quickly shows the level of sound output. Proper attention to the peak meter results in
the punchiest possible sound without audible distortion.
11) Zone EQ: Adjusts the Treble, Middle, and Bass frequencies respectively of the zone audio.
12) Headphone Gain Control – Adjusts headphone volume.
13) Headphone Jack- for plugging in your headphones.