1. DL manuals
  2. W Audio
  3. Speakers
  4. PSR-10A NEO
  5. User Manual

W Audio PSR-10A NEO User Manual

Manual is about: Active speaker W Audio PSR-10A NEO

Summary of PSR-10A NEO

  • Page 1

    English w w w . P r o l i g h t . C o . U k user manual psr 10a neo speaker p r o f e s s i o n a l s o u n d r e i n f o r c e m e n t order code: spea31c.

  • Page 2

    Warning for your own safety, please read this user manual carefully before your initial start-up! Unpacking instructions immediately upon receiving this product, carefully unpack the carton and check the contents to ensure that all the parts are present, and have been received in good condition. Not...

  • Page 3

    3 important: the manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections w...

  • Page 4

    4 please note that speaker systems can move due to bass beats and vibrations. Furthermore, unintended pushing on the speakers present a further risk. The speaker system must always be secured against moving or the respective area has to be blocked..

  • Page 5

    The given maximum power of the speaker system describes short term peaks the system can handleasamaximum.Thecorrespondingrmspoweris-asofallcomparablesystems(also fromothermanufactures)-significantlylower.Themaximumpowerofthespeakersystemmust never be exceeded. When operating the speaker system, plea...

  • Page 6

    Thepsrseriesmustalwaysbeprovidedwithenoughstability.Thespeaker(s)basesurface mustalwaysbesufficientlydimensionedinrelationtotheotherspeaker(s)inordertopreventthe cabinets tilting over. Make sure that the area below the installation place is blocked when rigging, derigging or servicing the system. Pl...

  • Page 7

    7 overview: 1, mic volume controls with this control you can set the desired volume level of the microphone. 2, volume control with this control you can set the desired volume of the line input. 3, treble control with this control you can add or decrease the speaker high frequency. Adding high frequ...

  • Page 8

    8 installation stacking the psr speakers may only be installed on top of another speaker system if both systems are clamped up to each other via appropriate clamping belts and protected against tilting over. Satellite system the satellite system must always provide enough stability. The subwoofer’sb...

  • Page 9

    Installation on a speaker stand the speaker system may only be installed on a speaker stand if the original speaker system is equipped with an appropriate stand adaptor. Stands or satellite systems must only be installed on a plane areawithamaximuminclinationangleof5˚. Caution:speakersystemsinstalle...

  • Page 10

    Overhead installation ifthespeakersystemistobeinstalledwithamountingheightofmorethan1meter(e.G.Ona stage or framework), the speaker system must always be secured with an appropriate secondary securing attachment. The installation must always be secured with a secondary safety attachment. E.G. An app...

  • Page 11

    Secondary attachment please note: the speaker system must always be secured with three appropriate eye bolts and three appropriate safety ropes. Theeyeletsandthesafetyropesmustalwaysholdatleast12timestheweightofthespeaker system. 11 please note: before installing the eye bolts, make sure that the th...

  • Page 12

    Wall installation the speaker system can only be installed on a wall, if the original speaker system is equipped with an appropriate mounting point. 12 before attaching the speaker system, make sure that the installation area can hold a minimum point load of 10timestheinstallationsweight. (e.G.13kgs...

  • Page 13

    Suspended installation (cont...) procedure step 1: remove the plastic bolt covers. Step 2: install the eye bolts in the threaded holes on the speaker system. The eye bolts must be tightened until the stop position, hand tight without any tools. Step 3:installtheboltonchainlinkinthefirstandlastlinksa...

  • Page 14

    Psr-10a neo specifications: output power: ...........................................................................................................................250w freq.Range(-10db):...................................................................................................60hz-20khz ma...

  • Page 16

    W w w . P r o l i g h t . C o . U k.