WABCO smatrboard User Manual - page 13
SmartBoard Display / Controller (EN) 13
Maintenance / Cleaning / Disposal
1
2
3
4
5
6
7
8
Cleaning/Servicing the SmartBoard device
Disconnect the power supply
when performing cleaning and
maintenance work!
The SmartBoard device in itself is
maintenance-free.
Occasional cleaning, depending
on the operating environment,
is recommended.
Cleaning
Abb. 8
SmartBoard device closed
1
Protective cover
To prevent damage to the
display or keypad, no solvents or
other chemicals must come into
contact with the SmartBoard
device.
The SmartBoard device must only be
cleaned with a soft, damp cloth without
cleaning agent.
NOTICE
Using high-pressure cleaners!
The SmartBoard device can be damaged
by high-pressure cleaners.
Ensure before cleaning that the cover
of the SmartBoard device is closed.
Do not spray water jets directly
at the SmartBoard device.
Open the protective cover and clean
the user interface / display with a soft /
damp cloth.
Check that the protective cover is not
damaged - replace the protective
cover if cracks/splits are detected in
the plastic.
SB - 005
1